Use and Care Manual
11 ENGLISH
NOTE: When installing the wheel, be sure to attach
the anges so that the at side of ange faces the
wheel, and attach the ring that matches the inner
diameter of the wheel.
2 3
4
1
2
Fig.10
► 1. Hex bolt 2. Flange 3. Ring 4. Abrasive cut-o
wheel / diamond wheel
Connecting to water supply
1. Prepare a water hose.
2. Connect the coupling sleeve to the water hose by
turning the coupling sleeve.
1
2
Fig.11
► 1. Water hose 2. Coupling sleeve
3. Connect the water hose to the water supply.
When connecting to a water faucet, use a suitable tting
such as hose band or water tap joint.
1
2
3
Fig.12
► 1. Hose band 2. Water tap joint 3. Water hose
NOTE: The tting depends on the shape of the faucet
to which you connect. Prepare a suitable commercial-
ly-bought tting.
NOTE: If you use a water tap joint, prepare another
coupling sleeve and attach it to the other end of the
hose.
NOTE: When using a water pump, follow the instruc-
tions of your water pump to connect the water hose.
4. Push the coupling sleeve into the water inlet until it
locks with a click.
1
2
3
Fig.13
► 1. Coupling sleeve 2. Water inlet 3. Cock
NOTICE: Keep the cock closed until you start the
cutting operation with water feeding. For how to
feed water, refer to the section for the operation.
OPERATION
CAUTION: Be sure to hold the workpiece
rmly down on a stable bench or table during
operation.
CAUTION: Do not twist or force the tool in the
cut, or the motor may be overloaded or the work-
piece may break.