Use and Care Manual

9 ENGLISH
To remove the bit, pull the release cover down all the
wayandpullthebitout.
2
1
►1. Bit 2. Release cover
Bit angle
Thebitcanbesecuredat12di󰀨erentangles.To
change the bit angle, slide the change ring cover for-
ward, then turn the change ring cover to change the bit
angle. At the desired angle, slide the change ring cover
back to the original position. The bit will be secured in
place.
After changing the bit angle, make sure the angle is
xedbytryingtorotatethebit.
1
►1. Change ring cover
Dust extractor attachment
Optional accessory
1. Install the hose holder (A).
Loosen the clamp nut, and then remove the hex bolt.
Install the hose holder (A) between the hex bolt and the
clampnutbytighteningtheclampnutrmly.
1
2
3
►1. Hex bolt 2. Hose holder (A) 3. Clamp nut
2. Attachtheholderjointtothetool,andthenattach
thehoseholder(C)totheholderjoint.
1
2
►1.Holderjoint2. Hose holder (C)
NOTE:Thehosejointcanbeattachedtoeitherside
of the tool.
WARNING: Use the mounting part of the tool
only for attaching the holder joint.
Usingthemountingpartforanyotherpurposemay
cause an unexpected accident.