Instruction manual

2
ENGLISH (Original instructions)
SPECIFICATIONS
Model GN900
Nail length X Shank diameter Nail L :50 mm - 90 mm d : 2.9 mm - 3.3 mm
Nail capacity 40 nails (1strip)
Nail collation angle (degree) 34
Figure of nail head Clipped
Dimensions (L X H X W) 321 mm X 108 mm X 368 mm
Net weight 3.3 kg
Rated voltage D.C. 7.2 V
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
END107-5
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･ Read instruction manual.
･ Container under pressure, keep away
from temperatures over 50℃ (for ex.
sun radiation) Keep container in a well
ventilated place.
･ Use only outside or well ventilated
rooms. Do not breathe gas.
･ Do not use near flames or sprays on
heated surfaces. In use, may form
flammable/explosive vapour-air mixture.
･ Do not damage, puncture or burn even
after use.
･ Wear safety glasses.
･ Keep fingers away from trigger when not
driving fasteners to avoid accidental
firing.
･ Use only in ventilated area to avoid
nausea and unconsciousness. Never
use tool in combustible atmospheres.
The tool exhaust may ignite flammable
materials.
･ Do not use on scaffoldings, ladders.
･ Warning: hot surface!
Do not touch around this symbol.
Touching the surface may cause burns
or injuries.
･ Only for EU countries
Do not dispose of electric equipment or
battery pack together with household
waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic equipment, 2006/66/EC on
batteries and accumulators and waste
batteries and accumulators and their
implementation in accordance with
national laws, electric equipment and
battery pack that have reached the end
of their life must be collected separately
and returned to an environmentally
compatible recycling facility.
ENE059-1
Intended use
The tool is intended for the preliminary interior work such
as fixing floor joists or common rafters and framing work
in 2 “x 4” housing.
ENG905-1
Noise
The typical A-weighted noise level determined according
to EN792:
Sound pressure level (L
pA
) : 89 dB(A)
Sound power level (L
WA
) : 102 dB(A)
Uncertainty (K) : 3 dB(A)
Wear ear protection
ENG904-1
Vibration
The vibration emission value determined according to
EN792:
Vibration emission (a
h
) : 2.5 m/s
2
or less
Uncertainty (K) : 1.5 m/s
2
ENG901-1
•
The declared vibration emission value has been
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
• The declared vibration emission value may also be
used in a preliminary assessment of exposure.
Cd
Ni-MH
Li-ion