Use and Care Manual

10 ENGLISH
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
1
2
3
Fig.15
► 1. Groove 2. Hook 3. Screw
Hex wrench storage
When not in use, store the hex wrench as shown in the
gure to keep it from being lost.
1
Fig.16
► 1. Hex wrench
OPERATION
Testing the safety system
WARNING: Make sure all safety systems are
in working order before operation. Failure to do
so may cause personal injuries.
1
2
3
4
Fig.17
► 1. Trigger-lock button 2. Switch trigger 3. Contact
element 4. Magazine
Test safety systems as follows for possible fault before
operation.
1.
Unload pin nails from the tool and keep the magazine opened.
2. Install the battery cartridge and release the trigger lock.
3. Pull the switch trigger without touching the contact
element against the material.
4. Touch the contact element against the material
without pulling the switch trigger.
If the tool operates in the case of 3 or 4 above, the
safety systems are faulty. Stop using the tool immedi-
ately and ask your local service center.
Driving pin nails
WARNING: Do not use this pin nailer for fas-
tening electrical cables. It is not designed for elec-
tric cable installation and may damage the insulation
of electric cables thereby causing electric shock or
re hazards.
WARNING: Continue to place the contact
element rmly on the material until the pin nail is
driven completely. Unintentional ring may cause
personal injuries.
CAUTION: Hold the tool rmly during
operation.
CAUTION: Do not use the tool beyond the
continuous operating time allowed. It otherwise
may cause damages to the tool resulting in personal
injury.
NOTICE: The tool will not restart fastening
after ve seconds no switch operation while the
contact element is placed on the workpiece. Pull
the contact element free from the workpiece and
reposition it in place to restart fastening.