Owner's Manual

Installing or removing the bit

Clean the bit shank before installing the bit.

Insert the bit into the tool. Turn the bit and push it in until it

engages.

If the bit cannot be pushed in, remove the bit. Pull the chuck

cover down a couple of times. Then insert the bit again. Turn

the bit and push it in until it engages.

After installing, always make sure that the bit is securely held

in place by trying to pull it out.

To remove the bit, pull the chuck cover down all the way and

pull the bit out.

Bit angle

The bit can be secured at 12 different angles. To change the

bit angle, slide the change ring forward, then turn the change

ring to change the bit angle. At the desired angle, slide the

change ring back to the original position. The bit will be

secured in place.

OPERATION

Position the bit at the location to be chipped, then pull the

switch trigger. Apply slight pressure on the tool so that the

tool will not bounce around, uncontrolled. Pressing very hard

on the tool will not increase the efficiency.

NOTE:

• When removing tiles with a scaling chisel, apply the

chisel to the bottom of tiles as shown in the figure. If you

operate the tool with the chisel applied to the top surface

of tiles, the service life of the chisel will be shortened.

1. Bit

2. Chuck cover

002910

1. Bit

2. Chuck cover

002911

1. Change ring

002936

1. Scaling chisel

2. Tile

002941