ENGLISH Demolition Hammer MODEL HM0810 MODEL HM0810B 004866 004954 DOUBLE INSULATION I N S T R U C T I O N M A N U A L WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
SPECIFICATIONS Model Blows per minute HM0810 2900 Overall length 410 mm Net weight 5.3 kg Safety class HM0810B min-1 2900 min-1 433 mm 5.3 kg /II • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Note: Specifications may differ from country to country. SYMBOLS END201-1 The following show the symbols used for the tool. Be sure that you understand their meaning before use. ...................Read instruction manual. .....
SAFETY INSTRUCTIONS ENA001-2 WARNING: When using electric tools, basic safety precautions, including the following, should always be followed to reduce the risk of fire, electric shock and personal injury. Read all these instructions before operating this product and save these instructions. For safe operations: 1. Keep work area clean. Cluttered areas and benches invite injuries. 2. Consider work area environment. Do not expose power tools to rain. Do not use power tools in damp or wet locations.
ADDITIONAL SAFETY RULES FOR TOOL 1. Hold tools by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a “live” wire will make exposed metal parts of the tool “live” and shock the operator. 2. Wear ear protectors when using the tool for extended periods. Prolonged exposure to high intensity noise can cause hearing loss. Wear a hard hat (safety helmet), safety glasses and/or face shield.
FUNCTIONAL DESCRIPTION • 002887 2 CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Switch action 1 CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released. To start the tool, simply pull the switch trigger. Release the switch trigger to stop. For continuous operation, pull the switch trigger and then push in the lock button.
002914 For HM0810B Clean the bit shank before installing the bit. Press in the tool retainer and turn it until the red dots on the tool retainer and the tool holder are aligned. Release the tool retainer. 002915 Insert the bit into the tool holder as far as it will go. Press in the tool retainer and turn it a full 180 degrees. Then release it to secure the bit. To remove the bit, follow the installation procedure in reverse. 1 2 1. Red dot (Tool holder) 2. Red dot (Tool retainer) 1 1.
002949 Use a hex wrench to remove the rear cover. 002950 Use a screwdriver to remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps. 002963 Lubrication 1 2 1. Hex wrench 2. Rear cover 1 2 1. Screwdriver 2. Brush holder cap This tool requires no hourly or daily lubrication because it has a greasepacked lubrication system. It should be relubricated after every 6 months of operation.
ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita service center.
Memo 9
Memo 10
Memo 11
Makita Corporation 883521I5