ENGLISH INSTRUCTION MANUAL Demolition Hammer HM0830 005813 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
ENGLISH SPECIFICATIONS Model HM0830 Blows per minute 2,700 min-1 Overall length 390 mm Net weight 4.5 kg Safety class /II • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Note: Specifications may differ from country to country. END201-3 EN60745. ENH101-6 Symbols EC-DECLARATION OF CONFORMITY The following show the symbols used for the equipment. Be sure that you understand their meaning before use.
16. Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. 17. Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. 18. Disconnect the plug from the power source and/or the battery pack from the power tool before making any adjustments, changing accessories, or storing power tools.
2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. FUNCTIONAL DESCRIPTION Use auxiliary handles supplied with the tool. Loss of control can cause personal injury. Hold power tools by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator. Wear a hard hat (safety helmet), safety glasses and/or face shield.
Installing or removing the bit 1 2 Replacing carbon brushes 1. Tool retainer 2. Push button 1. Commutator 2. Insulating tip 3. Carbon brush 2 1 3 005816 001146 Press the push button and pivot the tool retainer to the side. Insert the bit into the tool barrel as far as it will go. Return the tool retainer to its original position to secure the bit. To remove the bit, follow the installation procedure in reverse.
ACCESSORIES Lubrication 2 1. Hex wrench 2. Hex bolts 1 CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center.
Makita Corporation Anjo, Aichi, Japan 884584-220 8
