Specifications

7
Bit angle
The bit can be secured at 16 different angles. To change the bit angle, slide
the change ring forward, then turn the change ring to change the bit angle. At
the desired angle, slide the change ring back to the original position. Then turn
the change ring slightly so that the bit will be secured in place with a little click.
OPERATION
Chipping/Scaling/Demolition
Hold the tool firmly with both hands. Turn the tool on and apply slight pressure
on the tool so that the tool will not bounce around, uncontrolled. Pressing very
hard on the tool will not increase the efficiency.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and unplugged before
attempting to perform inspection or maintenance.
Replacing carbon brushes
When the resin insulating tip inside the carbon brush is exposed to contact the
commutator, it will automatically shut off the motor. When this occurs, both car-
bon brushes should be replaced. Keep the carbon brushes clean and free to
slip in the holders. Both carbon brushes should be replaced at the same time.
Use only identical carbon brushes.
Remove the screws which secure the rear cover. Pry up the rear cover with a
screwdriver and remove it.
1. Change ring
1
002937
002943
1. Commutator
2. Insulating tip
3. Carbon brush
1
2
3
001146
1. Screwdriver
2. Rear cover
3. Screws
1
2
3
002951