Specifications

Use a screwdriver to remove the brush holder caps. Take out the worn carbon

brushes, insert the new ones and secure the brush holder caps.

Lubrication

This tool requires no hourly or daily lubrication because it has a grease-

packed lubrication system. It should be relubricated after every 6 months of

operation. Send the complete tool to Makita Authorized or Factory Service

Center for this lubrication service. However, if circumstances require that you

should lubricate it by yourself, proceed as follows.

Run the tool for several minutes to warm it up. Switch off and unplug the tool.

Remove the crank cap using a socket wrench. Rest the tool on the table with

the bit end pointing upwards. This will allow the old grease to collect inside the

crank housing.

Wipe out the old grease inside and replace with a fresh grease (30 g; 1 oz).

Use only Makita genuine hammer grease (optional accessory). Filling with

more than the specified amount of grease (approx. 30 g; 1 oz) can cause faulty

hammering action or tool failure. Fill only with the specified amount of grease.

Reinstall the crank cap and tighten with the socket wrench.

CAUTION:

• Do not tighten the crank cap excessively. It is made of resin and is

subject to breakage.

To ma in ta in p ro du ct SA FE TY a nd RE LI AB I LI TY, re p ai rs, a ny o th er ma in te -

nance or adjustment should be performed by Makita Authorized Service Cent-

ers, always using Makita replacement parts.

ACCESSORIES

CAUTION:

• These accessories or attachments are recommended for use with your Makita tool specified in this manual. The

use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or

attachment for its stated purpose.

If you need any assistance for more details regarding these accessories, ask your local Makita service center.

1. Screwdriver

2. Brush holder cap

002952

1. Socket wrench

2. Crank cap

002965

1. Hammer grease

002966

• Bull point

• Bull point(SDS-max)

• Cold chisel(SDS-max)

• Scaling chisel(SDS-max)

• Clay spade(SDS-max)

• Bit grease

• Safety goggles

• Hammer grease

• Prastic carrying case