ENGLISH (Original instructions) INSTRUCTION MANUAL Demolition Hammer HM1213C HM1203C 009939 DOUBLE INSULATION IMPORTANT: Read Before Using.
ENGLISH (Original instructions) SPECIFICATIONS Model HM1213C HM1203C 950 - 1,900 min-1 Blows per minute Overall length 576 mm Net weight 10.8 kg Safety class 9.7 kg II • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Note: Specifications may differ from country to country. • Weight according to EPTA-Procedure 01/2003 END201-4 Uncertainty (K) : 2.
account of all parts of the operating cycle such as the times when the tool is switched off and when it is running idle in addition to the trigger time). instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. ENH213-1 EC Declaration of Conformity The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. Work area safety 1. Keep work area clean and well lit.
23. Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. Service 24. Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. 25.
10. 11. 12. 13. 14. 15. Speed change Keep hands away from moving parts. Do not leave the tool running. Operate the tool only when hand-held. Do not point the tool at any one in the area when operating. The bit could fly out and injure someone seriously. Do not touch the bit or parts close to the bit immediately after operation; they may be extremely hot and could burn your skin. Do not operate the tool at no-load unnecessarily. Some material contains chemicals which may be toxic.
Insert the bit into the tool. Turn the bit and push it in until it engages. The green power-ON indicator lamp lights up when the tool is plugged. If the indicator lamp does not light up, the mains cord or the controller may be malfunction. The indicator lamp is lit but the tool does not start even if the tool is switched on, the carbon brushes may be worn out, or the controller, the motor or the ON/OFF switch may be malfunction.
This tool requires no hourly or daily lubrication because it has a grease-packed lubrication system. However, it is recommended to periodically replace the grease for longer tool life. Run the tool for several minutes to warm it up. Switch off and unplug the tool. Loosen the six screws and remove the handle. Note that the top screws are different from other screws. 1. Screws 1 009944 The bit can be secured at 12 different angles.
• 1. Grease 1 • • • • • • 009953 CAUTION: Be careful not to damage the connector or lead wires especially when wiping out the old grease. To reassemble the tool, follow the disassembling procedure in reverse. • • CAUTION: Do not tighten the crank cap excessively. It is made of resin and is subject to breakage. 1. Connector 2. White 3. Black 3 1 2 009954 Connect the connector firmly and then reinstall the handle.
Makita Corporation Anjo, Aichi, Japan 884887B222 www.makita.
