ENGLISH (Original instructions) INSTRUCTION MANUAL Demolition Hammer HM1214C 009972 DOUBLE INSULATION IMPORTANT: Read Before Using.
ENGLISH (Original instructions) SPECIFICATIONS Model HM1214C Blows per minute 950 - 1,900 min-1 Overall length 700 mm Net weight 12.3 kg Safety class II • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Note: Specifications may differ from country to country.
And are manufactured in accordance with the following standards or standardised documents: EN60745 The technical documentation is kept by our authorised representative in Europe who is: Makita International Europe Ltd. Michigan Drive, Tongwell, Milton Keynes, Bucks MK15 8JD, England The conformity assessment procedure required by Directive 2000/14/EC was in Accordance with annex VIII.
GEB004-6 16. Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing, and gloves away from moving parts. Loose clothes, jewellery or long hair can be caught in moving parts. 17. If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. Use of dust collection can reduce dust-related hazards. Power tool use and care 18. Do not force the power tool. Use the correct power tool for your application.
WARNING: Number on adjusting dial 5 4 3 2 1 DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. 009956 NOTE: • Blows at no load per minute becomes smaller than those on load in order to reduce vibration under no load, but this does not show trouble.
After installing, always make sure that the bit is securely held in place by trying to pull it out. To remove the bit, pull the releasing cover down all the way and pull the bit out. Side handle (auxiliary handle) 1. Side handle 2. Clamp nut 1 1. Releasing cover 1 2 009977 The side handle can be swung 360° on the vertical and secured at any desired position. It also secures at eight different positions back and forth on the horizontal.
Pull out the grease cap in the direction of arrow and remove it. MAINTENANCE • • CAUTION: Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result. 1. Hammer grease 2. Brush holder unit 3. Carbon brush 1 2 Lubrication 3 010073 Then replenish with fresh grease (60g). Use only Makita genuine hammer grease (optional accessory).
Makita Corporation Anjo, Aichi, Japan 884901B224 8 www.makita.
