ENGLISH INSTRUCTION MANUAL Electric Breaker HM1400 HM1400K 007629 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
ENGLISH SPECIFICATIONS Model HM1400 Blows per minute (min-1) 1,200 1,200 Overall length 613 mm 600 mm Net weight HM1400K 17 kg Safety class /II • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Note: Specifications may differ from country to country. END201-4 accordance with Council Directive, 2000/14/EC.
power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. 17. Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. 18. Disconnect the plug from the power source and/or the battery pack from the power tool before making any adjustments, changing accessories, or storing power tools.
3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. FUNCTIONAL DESCRIPTION Loss of control can cause personal injury. Hold power tools by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator. Wear a hard hat (safety helmet), safety glasses and/or face shield. Ordinary eye or sun glasses are NOT safety glasses.
When the resin insulating tip inside the carbon brush is exposed to contact the commutator, it will automatically shut off the motor. When this occurs, both carbon brushes should be replaced. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Use only identical carbon brushes. Use a screwdriver to remove the holder cap plates. 1. Notched portion 2.
Remove the plate 50 using a screwdriver, then replenish with fresh grease (60 g). Use only Makita genuine hammer grease (optional accessory). Filling with more than the specified amount of grease (approx. 60 g) can cause faulty hammering action or tool failure. Fill only with the specified amount of grease. 1. Hammer grease 1 007637 Reinstall the plate 50 and secure with the screws.
Makita Corporation Anjo, Aichi, Japan 883520-223 8
