User Manual

5
ENGLISH (Original instructions)
Explanation of general view
1-1. Switch trigger
1-2. Lock button
2-1. Lamp
3-1. Reversing switch lever
4-1. Quick change chuck for SDS-plus
4-2. Change cover line
4-3. Change cover
5-1. Spindle
5-2. Quick change drill chuck
5-3. Change cover line
5-4. Change cover
6-1. Rotation with hammering
6-2. Rotation only
6-3. Action mode changing knob
7-1. Rotation with hammering
7-2. Action mode changing knob
8-1. Rotation only
9-1. Hammering only
10-1. Protrusions
10-2. Grooves
11-1. Bit shank
11-2. Bit grease
12-1. Bit
13-1. Bit
13-2. Chuck cover
14-1. Action mode changing knob
16-1. Grip base
16-2. Lock button
16-3. Depth gauge
17-1. Toothed side of hex hole marking
on the grip base
17-2. Toothed side of the depth gauge
18-1. Lock button
19-1. Toothed side of hex hole marking
on the grip base
19-2. Toothed side of the depth gauge
20-1. Dust cup
21-1.
symbol
21-2. Grooves
21-3. Dust cup
22-1. Bit
22-2. Chuck cover
23-1. Attachment at the foot of dust cup
24-1. Bellows
24-2. Attachment
25-1. Inside periphery
25-2. Carved side
25-3. Attachment
25-4. Cap
25-5. Groove
26-1. Cap
26-2. Attachment
29-1. Blow-out bulb
31-1. Chuck adapter
31-2. Keyless drill chuck
32-1. Quick change chuck for SDS-plus
32-2. Change cover line
32-3. Change cover
33-1. Spindle
33-2. Quick change drill chuck
33-3. Change cover line
33-4. Change cover
34-1. Sleeve
34-2. Ring
34-3. Quick change drill chuck
35-1. Dust cap
SPECIFICATIONS
Model HR2300 HR2310T HR2600 HR2601 HR2610 HR2610T HR2611F HR2611FT
Concrete 23 mm 26 mm
Core bit 68 mm 68 mm 68 mm
Diamond core bit (dry type) 70 mm 80 mm 80 mm
Steel 13 mm 13 mm 13 mm
Capacities
Wood 32 mm 32 mm 32 mm
No load speed (min
-1
) 0 - 1,200
Blows per minute 0 - 4,600
Overall length 356 mm 380 mm 361 mm 385 mm 361 mm 385 mm
Net weight 2.7 kg 2.9 kg 2.8 kg 2.9 kg 2.8 kg 2.9 kg 2.9 kg 3.0 kg
Safety class /II
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
ENE042-1
Intended use
The tool is intended for hammer drilling and drilling in
brick, concrete and stone.
It is also suitable for drilling without impact in wood, metal,
ceramic and plastic.
ENF002-2
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.