Operators Manual
2
ENGLISH (Original instructions)
SPECIFICATIONS
Model HR3200C HR3210C HR3210FCT
Tungsten-carbide tipped bit 32 mm
Concrete
Core bit 90 mm
Steel 13 mm
Capacities
Wood 32 mm
No load speed (min
-1
) 315 - 630
Blows per minute 1,650 - 3,300
Overall length 398 mm 424 mm
Net weight 4.8 kg 5.2 kg 5.4 kg
Safety class /II
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
END201-5
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･ Read instruction manual.
･ DOUBLE INSULATION
･ Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic equipment and its
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally compatible recycling
facility.
ENE044-1
Intended use
The tool is intended for hammer drilling in brick, concrete
and stone as well as for chiselling work.
ENF002-1
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
ENG905-1
Noise
The typical A-weighted noise level determined according
to EN60745:
Model HR3200C,HR3210C
Sound pressure level (L
pA
) : 89 dB(A)
Sound power level (L
WA
) : 100 dB(A)
Uncertainty (K) : 3 dB(A)
Model HR3210FCT
Sound pressure level (L
pA
) : 88 dB(A)
Sound power level (L
WA
) : 99 dB(A)
Uncertainty (K) : 3 dB(A)
Wear ear protection
ENG900-1
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Model HR3200C
Work mode : hammer drilling into concrete
Vibration emission (a
h,HD
) : 18.0 m/s
2
Uncertainty (K) : 1.5 m/s
2
Work mode : chiseling
Vibration emission (a
h,CHeq
) : 12.5 m/s
2
Uncertainty (K) : 1.5 m/s
2
Work mode: drilling into metal
Vibration emission (a
h,D
) : 2.5 m/s
2
or less
Uncertainty (K) : 1.5 m/s
2
Model HR3210C
Work mode : hammer drilling into concrete
Vibration emission (a
h,HD
) : 10.0 m/s
2
Uncertainty (K) : 1.5 m/s
2