Use and Care Manual

8 ENGLISH

► 1. Hex wrench 2. Shaft lock 3. Hex bolt 4. Outer

ange 5. Loosen 6. Tighten

2. Remove the hex bolt and outer ange.

3. Turn the lever to open the blade guard.

► 1. Lever

4. Remove the blade.

► 1. Hex bolt 2. Outer ange 3. Circular saw blade

4. Inner ange

To install the circular saw blade, follow the removal

procedure in reverse.

Mount the inner ange with its recessed side facing

outward onto the mounting shaft and then place saw

blade, outer ange and hex bolt.

► 1. Mounting shaft 2. Inner ange 3. Circular saw

blade 4. Outer ange 5. Hex bolt

WARNING: BE SURE TO TIGHTEN THE HEX

BOLT CLOCKWISE SECURELY. Also be careful

not to tighten the bolt forcibly. Slipping your hand

from the hex wrench can cause a personal injury.

Blade guard cleaning

When changing the circular saw blade, make sure to

also clean the upper and lower blade guards of accu-

mulated sawdust as discussed in the Maintenance

section. Such efforts do not replace the need to check

lower guard operation before each use.

Hex wrench storage

When not in use, store the hex wrench as shown in the

gure to keep it from being lost.

► 1. Hex wrench