ENGLISH (Original instructions) INSTRUCTION MANUAL Cordless Recipro Saw JR100D JR102D 012163 IMPORTANT: Read Before Using.
ENGLISH (Original instructions) SPECIFICATIONS Model JR100D Length of stroke Strokes per minute (min-1) Max. cutting capacities JR102D 13 mm 0 - 3,300 Pipe 50 mm Wood 50 mm Overall length (with battery) 355 mm Net weight 1.2 kg Rated voltage 1.1 kg D.C. 10.8V • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Specifications and battery cartridge may differ from country to country.
21. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tool’s operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. 22. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. 23. Use the power tool, accessories and tool bits etc.
2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 2. 3. Use clamps or another practical way to secure and support the workpiece to a stable platform. Holding the work by hand or against your body leaves it unstable and may lead to loss of control. Always use safety glasses or goggles. Ordinary eye or sun glasses are NOT safety glasses. Avoid cutting nails. Inspect workpiece for any nails and remove them before operation. Do not cut oversize workpiece.
Switch action FUNCTIONAL DESCRIPTION • Installing or removing battery cartridge 1 1. Lock-off button 2. Lock-off lever 3. Switch lever 4. Switch trigger 1 CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. 2 1. Buttons 2.
fixed. In this case, rotate the blade clamp sleeve fully, then make the sleeve fixed at the released position. For Model JR102D ASSEMBLY • CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. 3 4 1. Hex wrench 2. Bolt 3. Loosen 4. Tighten 1 Installing or removing the saw blade CAUTION: Always clean out all chips or foreign matter adhering to the blade, blade clamp and/or slider.
Hex wrench storage 1. Hex wrench 2. Projections 1 012173 2 • 012167 When not in use, store the hex wrench. It is fixed by two projections as shown in the figure to keep it from being lost. You can use the switch lever or trigger according to your work. NOTE: • If the tool is operated continuously until the battery cartridge has discharged, allow the tool to rest for 15 minutes before proceeding with a fresh battery.
Makita Corporation 885069A3 8 www.makita.
