Instruction manual

6
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing the saw blade
CAUTION:
• Always clean out all chips or foreign matter
adhering to the blade, blade clamp and/or slider.
Failure to do so may cause insufficient tightening
of the blade, resulting in a serious injury.
For Model JR100D
1
2
012161
Insert the recipro saw blade into the blade clamp as far
as it will go. The blade clamp sleeve rotates and the saw
blade is fixed. Make sure that the saw blade cannot be
extracted even though you try to pull it out.
CAUTION:
• If you do not insert the saw blade deep enough, the
saw blade may be ejected unexpectedly during
operation. This can be extremely dangerous.
NOTE:
• You can not use the jig saw blade with JR100D
1
2
012162
To remove the saw blade, rotate the blade clamp sleeve
in the direction of the arrow fully. The saw blade is
removed and the blade clamp sleeve is fixed at the
released position.
NOTE:
• If you remove the saw blade without rotating the
blade clamp sleeve fully, the sleeve may not be
fixed. In this case, rotate the blade clamp sleeve
fully, then make the sleeve fixed at the released
position.
For Model JR102D
1
2
3
4
012165
To install the saw blade, loosen the bolt by hex wrench.
When installing a jig saw blade, loosen the bolt only
three-quarter to one turn from the fully tightened position.
If the bolt is loosened too much, it may difficult to secure
the blade straight. In this case, fully tighten the bolt
without inserting the blade and loosen it three-quarter to
one turn again.
1
2
34
012229
012230
You can use both jig saw blades (B type) and recipro
saw blades according to your work. Insert the saw blade
straight into the blade clamp and tighten it by hex
wrench. Pull the saw blade lightly to make sure that the
saw blade does not fall off during operation.
To remove the saw blade, follow the installation
procedure in reverse.
1. Saw blade
2. Blade clamp
3. Hole for recipro
saw blade
4. Hole for jig saw
blade
1. Hex wrench
2. Bolt
3. Loosen
4. Tighten
1. Blade clamp
sleeve
2. Saw blade
1. Recipro saw
blade
2. Blade clamp
sleeve