Owner's Manual

Changing Blade Position
.Use the hex wrench provided to remove
the hex socket hd. bolt holding the shear
blade in place.
.Turn the shear blade and replace with
a
new one. Some power shears have one
or more washers between the shear blade
and the holder. Be sure to use the same
number of washers when reassembling.
Note: No washers are used for the
sta-
tionary blade.
I I
I I
Fig. 6
Thin-washers
@&
Blade holder
1 Fig. i
.To secure the shear blade, tighten the hex socket hd. bolt with the hex wrench provided.
Keep pressure on the shear blade while tightening it. After fastening the blade, check to
be sure that there
is no clearance between the shear blade and blade holder bevelled
surf ace.
Blade holder
No clearance
Hex socket hd bolt allowed
Shear blade
Fig. I
6