Use and Care Manual

misalignment or binding of moving parts, break
the power tool repaired before use.
Use the power tool, accessories and tool bits
theworktobeperformed.
gloves which may be entangled.
Have your power tool serviced by a quali¿ed
Follow instruction for lubricating and chang
equipment has a polarized plug (one blade
is wider than the other). This plug will ¿t in a
not ¿t fully in the outlet, reverse the plug. If it
still does not ¿t, contact a quali¿ed electrician
be sure the voltage supplied is the same as
that speci¿ed on the nameplate of the tool. A
speci¿ed for the tool can result in SERIOUS
tool. If in doubt, DO NOT PLUG IN THE TOOL.
When using an extension cord, be sure to use
of power and overheating. Table 1 shows the
and nameplate ampere rating. If in doubt, use
number, the heavier the cord.
like products, they cannot be used with abra
such as bars, rods, studs, etc.
ever possible. If supporting the workpiece
by hand, you must always keep your hand at
least 100 mm from either side of the saw blade.
small to be securely clamped or held by hand.
The workpiece must be stationary and
clamped or held against both the fence and the
table. Do not feed the workpiece into the blade
of cutting either in front or behind the saw
blade.