Instruction manual

Positioning

kerf

boards

This tool is provided with kerf boards in the turn base. The kerf boards are factory-adjusted

that the saw blade does not contact the kerf boards. Before use, adjust the kerf boards

as follows:

First unplug the tool. Loosen the all screws

each on left and right) which secure the

kerf boards. Retighten them to the extent

that the kerf boards can be easily moved

by hand. Lower the handle fully and press

the stopper pin to lock the handle in the

lowered position. Adjust the kerf boards

that the kerf boards just contact the

sides

blade teeth slightly. Tighten the all

screws (do not tighten firmly). After adjust-

ing the kerf boards, release the stopper pin

and raise the handle. Then tighten the

all

screws securely.

Kerf

board

LScrew

Left

bevel

cut Straight cut

CAUTION:

After changing the bevel angle, always readjust the kerf boards as described above.