Instruction manual

VOLTAGE WARNING: Before connecting the tool to a power source (receptacle,
outlet, etc.) be sure the voltage supplied is the same as that specified on the
nameplate of the tool. A power source with voltage greater than that specified
for the tool can result in SERIOUS INJURY to the user
- as well as damage to
the tool.
If in doubt, DO NOT PLUG IN THE TOOL. Using a power source with
voltage less than the nameplate rating is harmful to the motor.
ADDITIONAL SAFETY RULES
1.
2.
3.
4.
5.
6.
7.
8.
9.
IO.
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.
Wear eye protection.
Do not operate saw without guards in place.
Don't use the tool
in the presence of flammable liquids or gases.
Check the blade carefully for cracks or damage before operation.
Replace cracked or damaged blade immediately.
Use only flanges specified for this tool.
Be careful not to damage the arbor, flanges (especially the installing surface)
or bolt. Damage to these parts could result
in blade breakage.
Make sure that the turn base is properly secured
so it will not move during
operation.
For your safety, remove the chips, small pieces, etc. from the table top before
operation.
Avoid cutting nails. Inspect for and remove all nails from the workpiece before
operation.
Make sure the shaft lock is released before the switch is turned on.
Be sure that the blade does not contact the turn base
in the lowest position.
Hold the handle firmly. Be aware that the saw moves up or down slightly
during start-up and stopping.
Do not perform any operation freehand. The workpiece must be secured
firmly against the turn base and guide fence during all operations.
Keep hands out of path of saw blade. Avoid contact with any coasting blade.
It can still cause severe injury.
Never reach around saw blade.
Make sure the blade
is not contacting the workpiece before the switch is
turned on.
Before using the tool on an actual workpiece, let
it run for a while. Watch
for vibration or wobbling that could indicate poor installation or a poorly
balanced blade.
Wait until the blade attains full speed before cutting.
Stop operation immediately if you notice anything abnormal.
Do not attempt to lock the trigger in the on position.
5