H203D 中文 GB Version 1
Contents Installing batteries .................................................................. 4 Using the AC adapter (not supplied) ..................................... 5 Setting the clock .................................................................. 6-7 Updating your radio - DAB ..................................................... 8 Selecting a station - DAB ....................................................... 9 Secondary services - DAB .....................................................
1 10 2 11 3 4 5 9 8 7 6 13 17 16 14 15 18 12
Controls Speaker 2 LCD display 3 Station preset 4 Power button 5 Info / Menu button 6 Band button 7 Select button 8 Tuning up / down button 9 Volume up / down button 10 Emergency buzzer 11 Torch button 12 Torch 13 Multi purpose handle 14 DC IN socket 15 FM wire antenna compartment 16 Battery compartment 17 Bracket holder 18 USB socket for software upgrade 1 GB LCD Display A B C D E F G Sleep indicator Egg timer indicator AM / FM indicator Clock digits DAB indicator FM indicator Two line text display C D
Installing batteries 1. Position the radio face down on a soft surface. 2. Remove the catch as shown and lift out the battery cover. 3. Insert 2 x “ D “ size/UM-1/LR20 batteries. 4. Replace the battery cover and catch. 5. Reduced power, distortion, a “ stuttering “ sound are all signs that the batteries may need replacing. The batteries should be replaced when “Low Battery” shown on the display. 6.
Using the AC adaptor (not supplied) 1. Remove the rubber cover of DC in socket on the left hand side of your radio. GB 2. Insert the adaptor plug into the DC socket. 3. Plug the adaptor into mains socket outlet. Whenever the adaptor is used, the batteries are automatically disconnected. The AC adaptor should be disconnected from the mains supply and the radio when not in use. Note: For safety purpose, DO NOT use AC adaptor in the shower room. Use the batteries only.
Setting the clock Automatically updating the clock 1. Press and hold the Info/Menu button. 2. Press the Tuning up/down button until ‘System’ shown on the display, then press the Select button to enter the setting. 3. Press the Tuning up/down button until ‘Time’ shown on the display., then press the Select button to enter the setting. 4. Press the Tuning up/down until ‘Auto Update’ shown on the display, press the Select button to enter the setting. 5.
Manually setting the clock 1. Press and hold the Info/Menu button. GB 2. Press the Tuning up/down button until ‘System’ shown on the display, then press the Select button to enter the setting. 3. Press the Tuning up/down button until ‘Time’ shown on the display, then press the Select button to enter the setting. 4. Press the Tuning up/down button until ‘Set Time/Date’ shown on the display. Press the Select button to enter the setting. The digit will flash. 5.
Operating your radio - DAB 1. Press the Power button to switch on your radio. The display will show “Welcome to Digital Radio” for a few seconds. 2. If this is the first time the radio is used, scan of the Band III DAB channels will be carried out. The display will show “Welcome to DAB”. If the radio has been used before the last used station will be selected. 3.
Selecting a station - DAB 1. The top line of the display shows the name of the station currently selected. 2. Press the Tuning Up/Down buttons to scroll through the list of available stations. 3. Press and release the Select button to select the station. The display may show “Now tuning...” while your radio finds the new station. 4. Adjust the Volume up or Down buttons to set the sound level as needed. Note: If after selecting a station the display shows “Service not available “.
Display modes - DAB Your radio has seven display modes:1. Press the Info button to cycle through the various modes. a. Scrolling text b. Program Type c. Multiplex Name d. Time and date e. Frequency f . Bit rate & audio type g. Signal Strength 10 Displays scrolling text messages such as artist/track name, phone in number etc. Displays the type of station being listened to e.g. Pop, Classic, News etc. Displays the name of DAB multiplex to which the current station belongs.
Finding new stations - DAB As time passes new stations may become available. To allow the radio to find the available stations, it is recommended to carry out a full scan of the entire DAB Band III frequencies. 1. With the radio switched on and in DAB mode, press and hold the Info/Menu button to enter the setting. 2. Press the Tuning up/down button until ‘Full Scan’ shown on the display. Press Select button to carry out a full scan. The display will show "Scanning...
Manual Tuning - DAB Manual tuning allows you to tune directly to the various DAB Band III channels. Note that DAB stations are located in the range of 5A-13F. 1. Press and hold the Info/Menu to enter the setting. 2. Press Tuning up/down button until “Manual tune” shown on the display. Press the Select button to enter the setting. 3. Press either Tuning Up/Down buttons to select the required DAB channel. 4. Press the Select button to select the required DAB channel.
Dynamic Range Control settings - DAB Dynamic Range Control (also known as DRC) can make quieter sounds easier to hear when your radio is used in a noisy environment. 1. Press the Power button to switch on your radio. 2. Press and hold the Info/Menu button. 3. Press the Tuning Up/Down buttons until the display shows “DRC value”. 4. Press the Select button to enter the setting. 5. Press the Tuning Up/Down buttons to select the required DRC setting (the default is 0).
Manual Tuning- FM 1. Press the Power button to switch on your radio. 2. Press the Band button to select the FM band. Fully extend the wire antenna. 3. Press the Select button repeatedly until the display shows “Manual tune < >”. 4. Press either the Tuning Up or Down buttons to tune to a station. The frequency will change in steps of 50kHz. Pressing and holding one of the buttons will advance the frequency selection several times each second. 5.
Auto tuning - FM 1. Press the Power button to turn on the radio. GB 2. Press the Band button to get required waveband, then extend the FM wire antenna located in the battery compartment to get best reception. 3. Press the Select button repeatedly until ‘Auto tune <>’ shown on the display. 4. Press the Tuning Up button. Your radio will scan from the currently frequency direction upwards and will stop scanning when it finds a station of sufficient strength. 5.
Scan sensitivity setting Your radio will normally scan for FM broadcasts which are strong enough to give good reception. However, you may wish the Autoscan function to also be able to find weaker signals, possibly from more distant radio transmitters. Your radio includes a local / distant option for the Auto-scan function. 1. Press and hold Info/Menu button to enter the setting. 2. Press the Tuning up or down button until ‘FM Scan Zone’ shown on the display. Press Select to enter the setting. 3.
Display modes - FM In FM mode the bottom line of the display can be set any of four display options. 1. Press the Info button to cycle through the various options. a. Radio text b. Program Type c. Time and date d. Frequency Displays scrolling text messages such as artist/track name, phone in number etc. Displays the programme information for the station being listened to e.g. Pop, Classic, News, etc. Displays the current time and date. Displays the frequency of the station being listened to.
Recalling a preset - DAB and FM 1. Press the Power button to switch on your radio. 2. Select the required waveband. 3. Momentarily press the required Preset button. Your radio will then tune to the station stored in preset memory. Sleep function – Auto Off The sleep timer will automatically switch off your radio after a preset time has elapsed. 1. Press and hold the Info/Menu button. 2. Press the Tuning up/down button until ‘System’ shown on the display. Press the Select button to enter the setting. 3.
Egg timer (timer function) 1. Press and hold the Info/Menu button. GB 2. Press the Tuning up/down button until ‘System’ shown on the display. Press the Select button to enter the setting. 3. Press the Tuning up/down button until ‘Egg timer’ shown on the display. Press the Select button to enter the setting and the display will appear on the display. 4. Press the Tuning up/down button to select required time. Press the Select button to confirm the setting.
System reset If your radio fails to operate correctly, or some digits on the display are missing or incomplete carry out the following procedure. 1. Press and hold down Info button. 2. Repeatedly press the Tuning Up/Down buttons until ‘System’ shown on the display press the Select button to enter the setting. 3. Press the Tuning up/down button until ‘Factory Reset’ shown on the display, then press the Select button to enter the setting.
Software upgrade Software updates for your radio may be available in the future. As software updates become available software and information on how to update your radio can be found at: http://sg.sangean.com.tw/first/first.asp http://www.sangean.eu/first/first.asp www.sangean.com.au. For more information, please contact our Head Office by sending email to info@sangean.com GB 1. Press and hold the Info/Menu button to enter the setting in any wave band. 2.
Emergency buzzer To activate Emergency buzzer, press Emergency buzzer button. Press the button again to switch off the buzzer. Torch Press the torch button to turn on the torch. Note: The torch won’t turn off automatically. To turn off the torch, press torch button again. Multi-purpose handle Using the multi-purpose handle, you may hang or carry the radio when not used in bathroom.
Bracket You may install the supplied bracket on the wall with the help of the double sides tape back side to hang the radio.
Carrying strap Using the supplied carrying strap, you may hang or carry the radio when not used in bathroom.
Power requirements Mains via AC adaptor (not supplied) INPUT: 100-240V~ 50/60HZ OUTPUT: DC 5V/600mA GB Batteries: 2 x UM1 ( D size, LR20 ) Battery Life: Approx. 120 hours of listening for 4 hours a day at normal volume using alkaline batteries. Frequency Coverage: FM 87.50 – 108 MHz DAB+ (BAND III): 5A-13F If at any time in the future you should need to dispose of this product please note that: Waste electrical products should not be disposed of with household waste.
