ENGLISH INSTRUCTION MANUAL Cordless Impact Driver BTD130F BTD140 BTD141 008432 WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
ENGLISH SPECIFICATIONS Model BTD130F BTD140 Machine screw 4 mm - 8 mm Standard bolt 5 mm - 14 mm Capacities High tensile bolt BTD141 5 mm - 12 mm No load speed (min-1) 0 - 2,400 0 - 2,300 Impacts per minute 0 - 3,200 Overall length 146 mm 145 mm Net weight 1.4 kg 1.5 kg Rated voltage D.C.14.4 V D.C.18 V • Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
GEA006-1 personal injury. Use personal protective equipment. Always wear eye protection. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. 12. Prevent unintentional starting. Ensure the switch is in the off-position before connecting to power source and/or battery pack, picking up or carrying the tool. .
22. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. 23. Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. Battery tool use and care 24.
Switch action power. Never recharge a fully charged battery cartridge. Overcharging shortens the battery service life. Charge the battery cartridge with room temperature at 10 ﾟ C - 40 ﾟ C (50 ﾟ F - 104 ﾟ F). Let a hot battery cartridge cool down before charging it. 2. 3. 1. Switch trigger 1 FUNCTIONAL DESCRIPTION • 006246 CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool.
Reversing switch action 1. Bit 2. Sleeve 1 1. Reversing switch lever 2 A 1 B 006249 006248 For Model BTD141 To install the bit, insert the bit into the sleeve as far as it will go. This tool has a reversing switch to change the direction of rotation. Depress the reversing switch lever from the A side for clockwise rotation or from the B side for counterclockwise rotation. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled.
OPERATION Hold the tool firmly and place the point of the driver bit in the screw head. Apply forward pressure to the tool to the extent that the bit will not slip off the screw and turn the tool on to start operation. NOTE: • Use the proper bit for the head of the screw/bolt that you wish to use. • When fastening screw M8 or smaller, carefully adjust pressure on the switch trigger so that the screw is not damaged. • Hold the tool pointed straight at the screw.
Replacing carbon brushes 1. Limit mark 1 1. Hole 2. Carbon brush cap 1 2 006258 006304 Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Use only identical carbon brushes. Use a screwdriver to remove two screws then remove the rear cover. Make sure that the carbon brush cap have fit into the holes in brush holders securely. Reinstall the rear cover and tighten two screws securely.
Makita Corporation Anjo, Aichi, Japan 884617C221 12
