User Manual

6 ENGLISH
ENGLISH (Original instructions)
SPECIFICATIONS
Model: M2402 M2403
Wheel diameter 355 mm
Max. wheel thickness 3 mm
Hole diameter 25.4 mm
No load speed 3,800 min
-1
or 3,900 min
-1
No load speed di󰀨ers from country to country. Refer to the nameplate on the tool.
Dimensions
(L x W x H)
Model with front cover type safety
guard + 97.0 mm height base
500 mm x 280 mm x 630 mm 515 mm x 280 mm x 640 mm
Model with front cover type safety
guard + 77.0 mm height base
490 mm x 280 mm x 610 mm 500 mm x 280 mm x 620 mm
Model with center cap type safety guard 490 mm x 280 mm x 610 mm 500 mm x 280 mm x 620 mm
Net weight
Model with front cover type safety
guard + 97.0 mm height base
15.5 kg 15.3 kg
Model with front cover type safety
guard + 77.0 mm height base
14.5 kg 14.3 kg
Model with center cap type safety guard 14.0 kg 13.8 kg
Safety class
/II
• Due to our continuing program of research and development, the specications herein are subject to change
without notice.
• Specications may di󰀨er from country to country.
• Weight according to EPTA-Procedure 01/2014
Intended use
The tool is intended for cutting in ferrous materials with
appropriate abrasive cut-o󰀨 wheel. Follow all laws and
regulations regarding dust and work area health and
safety in your country.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
For public low-voltage distribution
systems of between 220 V and 250 V
Switching operations of electric apparatus cause volt-
age uctuations. The operation of this device under
unfavorable mains conditions can have adverse e󰀨ects
to the operation of other equipment. With a mains
impedance equal or less than 0.25 Ohms it can be pre-
sumed that there will be no negative e󰀨ects. The mains
socket used for this device must be protected with a
fuse or protective circuit breaker having slow tripping
characteristics.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-3-10:
Model M2402
Sound pressure level (L
pA
) : 98 dB(A)
Sound power level (L
WA
) : 108 dB (A)
Uncertainty (K) : 3.0 dB(A)
Model M2403
Sound pressure level (L
pA
) : 99 dB(A)
Sound power level (L
WA
) : 109 dB (A)
Uncertainty (K) : 3.0 dB(A)
NOTE: The declared noise emission value(s) has been
measured in accordance with a standard test method
and may be used for comparing one tool with another.
NOTE: The declared noise emission value(s) may
also be used in a preliminary assessment of exposure.
WARNING: Wear ear protection.
WARNING: The noise emission during actual
use of the power tool can di󰀨er from the declared
value(s) depending on the ways in which the
tool is used especially what kind of workpiece is
processed.
WARNING: Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
o󰀨 and when it is running idle in addition to the
trigger time).