ENGLISH (Original instructions) INSTRUCTION MANUAL Cordless Driver Drill MT070 MT071 011794 IMPORTANT: Read Before Using.
ENGLISH (Original instructions) SPECIFICATIONS Model Capacities No load speed (min-1) MT070 MT071 Steel 10 mm 13 mm Wood 25 mm 36 mm Wood screw 5.1 x 63 mm 6 mm x 75 mm Machine screw 6 mm High (2) 0 - 1,400 Low (1) 0 - 400 Overall length 201 mm Net weight 1.4 kg 223 mm 1.7 kg Rated voltage D.C. 14.4 V D.C. 18 V • Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
preventive safety measures reduce the risk of starting the power tool accidentally. 20. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users. 21. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tool’s operation.
GEB051-2 4. Use auxiliary handle(s), if supplied with the tool. Loss of control can cause personal injury. Hold power tool by insulated gripping surfaces, when performing an operation where the cutting accessory may contact hidden wiring. Cutting accessory contacting a "live" wire may make exposed metal parts of the power tool "live" and could give the operator an electric shock. Always be sure you have a firm footing. Be sure no one is below when using the tool in high locations. Hold the tool firmly.
• When the remaining battery capacity gets low: If you pull the switch trigger, the motor runs again but stops soon. In this case, to prevent over discharge, remove the battery cartridge from the tool and charge it • FUNCTIONAL DESCRIPTION CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Switch action 1. Switch trigger Installing or removing battery cartridge 1. Red indicator 2. Button 3.
Speed change ASSEMBLY 1. Speed change lever • 1 CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Installing or removing driver bit or drill bit 1 011799 To change the speed, first switch off the tool and then slide the speed change lever to the "2" side for high speed or "1" side for low speed. Be sure that the speed change lever is set to the correct position before operation. Use the right speed for your job.
• CAUTION: Make sure that the driver bit is inserted straight in the screw head, or the screw and/or bit may be damaged. MAINTENANCE CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance. • Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result.
Makita Corporation 884990-3 8 www.makita.
