ENGLISH (Original instructions) INSTRUCTION MANUAL Circular Saw MT560 MT580 004026 DOUBLE INSULATION IMPORTANT: Read Before Using.
ENGLISH (Original instructions) SPECIFICATIONS Model MT560 MT580 Blade diameter 165 mm 185 mm at 90° 56 mm 66 mm at 45° 37 mm 44 mm Max. cutting depth No load speed (min-1) 4,700 4,700 Overall length 273 mm 286 mm Net weight 3.7 kg Safety class 3.9 kg /II • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Specifications may differ from country to country.
before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. 21. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users. 22. Maintain power tools.
or loss of control. either side of the blade, but not in line with the blade. Kickback could cause the saw to jump backwards, but kickback forces can be controlled by the operator, if proper precautions are taken. • When blade is binding, or when interrupting a cut for any reason, release the trigger and hold the saw motionless in the material until the blade comes to a complete stop. Never attempt to remove the saw from the work or pull the saw backward while the blade is in motion or kickback may occur.
10. Do not support board or panel away from the cut. 000156 • • • • Do not use dull or damaged blades. Unsharpened or improperly set blades produce narrow kerf causing excessive friction, blade binding and kickback. Keep blade sharp and clean. Gum and wood pitch hardened on blades slows saw and increases potential for kickback. Keep blade clean by first removing it from tool, then cleaning it with gum and pitch remover, hot water or kerosene. Never use gasoline.
18. 19. 20. 21. Do not operate the saw if riving knife is bent. Even a light interference can slow the closing rate of a guard. Use extra caution when cutting damp wood, pressure treated lumber, or wood containing knots. Adjust speed of cut to maintain smooth advancement of tool for avoicling overheating the blade tips without decrease in blade speed. Avoid Cutting Nails. Inspect for and remove all nails from lumber before cutting.
For straight cuts, align the A position on the front of the base with your cutting line. For 45° bevel cuts, align the B position with it. FUNCTIONAL DESCRIPTION • CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Switch action 1. Switch trigger 2. Lock button 1 Adjusting depth of cut CAUTION: • After adjusting the depth of cut, always tighten the clamping screws securely.
outer flange and blade. To install the blade, follow the removal procedure in reverse. BE SURE TO TIGHTEN THE HEX BOLT CLOCKWISE SECURELY. Hex wrench storage 1. Hex bolt 2. Outer flange 3. Saw blade 4. Inner flange 3 2 1 004035 4 When not in use, store the hex wrench as shown in the figure to keep it from being lost. 004032 • OPERATION CAUTION: The inner flange has a 20 mm diameter on one side and a 19 mm diameter on the other. The side with 19 mm diameter is marked by "19".
MAINTENANCE • • CAUTION: Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result. Replacing carbon brushes 1. Limit mark 1 001145 Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders.
Makita Corporation Anjo, Aichi, Japan 884499B5 12 www.makita.
