Use and Care Manual

13 ENGLISH
1
►1. Screws
8. Placetheundercoversothat
on the under-
cover is aligned with on the lock lever.
9. While pressing the undercover, turn it clockwise
until on the undercover is aligned with on the lock
lever.
10. Makesurethatthelocklevertsinthegrooveon
the undercover.
1
►1. Lock lever
CAUTION: Never use the tool without install-
ing the undercover.
11. Remove the blade cover, and then turn on the tool
to check that it works properly.
NOTICE: If the shear blades do not operate prop-
erly, the blades are not engaging the crank prop-
erly. Remove the blades and install them again.
Installing or removing the chip
receiver
Optional accessory
CAUTION: When installing or removing the
chip receiver, always wear gloves and attach the
blade cover so that your hands and face do not
directly contact the blade.
Thechipreceivergathersdiscardedleavesandmakes
clean-up afterward much easier. It can be installed on
either side of the tool.
Toinstallthechipreceiver,pressitagainsttheshear
bladessothatthehookstintotheholesoftheshear
blades.
1
2
►1. Hooks 2. Holes
Toremovethechipreceiver,presstheleversonboth
sides to release the hooks.