Manual

FUNCTIONAL
DESCRIPTION
Ak CAUTION:
• Always be sure that the tool is switched off and
unpluggedbefore adjustingor checkingfunction on the
tool.
00365_
1. Motor unll housing
2. Index line
3. Scalering
4.Graduation
5. Locklever
Adjusting the depth of cut
Place the tool on a flat wood surface. Open the lock lever.
Turn the motor unit until the bit just touches the fiat surface.
Close the lock lever.
Rotate the scale ring until the zero-line is on the index line on
the motor unit. One graduation on the scale ring means the
cutting edge of the bit is exposed 1/64" below the base.
While holding up the base slightly, open the _ock lever and
turn the motor unit clockwise untilthe index line on the motor
unit reaches the desired depth indicated on the scale ring.
Close the lock lever firmly.
0C_861
1. ev_tch lever
Switch action
For RF1100 and RF1101
,_ CAUTION:
Before plugging in the toot, always check to see that the
tool is switched off.
Switch can be locked in "ON" position for ease of
operator comfort during extended use. Apply caution
when locking tool in "ON" position and maintain firm
grasp on tool.
To start the tool, move the switch lever to the I (ON) position.
To stop the tool, move the switch lever to the 0 (OFF) posi-
tion.
7