Operation Manual

13
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Straight & groove forming bits
• Edge forming bits
• Laminate trimming bits
• Straight guide
• Trimmer guide
• Guide holder
• Templet guides
• Templet guide adapter
• Lock nut
• Collet cone 12 mm, 1/2”
• Collet sleeve 6 mm, 8 mm, 10 mm
• Collet sleeve 3/8”, 1/4”
• Wrench 24
• Vacuum head set
Router bits
Straight bit (Fig. 37)
mm
“U” Grooving bit (Fig. 38)
mm
“V” Grooving bit (Fig. 39)
mm
Drill point flush trimming bit (Fig. 40)
mm
Drill point double flush trimming bit (Fig. 41)
mm
Board-jointing bit (Fig. 42)
mm
Corner rounding bit (Fig. 43)
mm
Chamfering bit (Fig. 44)
mm
Cove beading bit (Fig. 45)
mm
Ball bearing flush trimming bit (Fig. 46)
mm
Ball bearing corner rounding bit (Fig. 47)
mm
D A L 1 L 2
6
20 50 15
1/4”
12
12 60 30
1/2”
12
10 60 25
1/2”
886025
6
85018
1/4”
6
65018
1/4”
D A L 1 L 2 R
6 6 50 18 3
D A L 1 L 2 θ
1/4” 20 50 15 90°
D A L 1 L 2 L 3
12 12 60 20 35
8 8 60 20 35
6 6 60 18 28
D A L 1 L 2 L 3 L 4
6 6 70 40 12 14
D A 1 A 2 L 1 L 2 L 3
12 38 27 61 4 20
D A 1 A 2 L 1 L 2 L 3 R
6 25 9 48 13 5 8
6 20 8 45 10 4 4
D A L 1 L 2 L 3 θ
6 23 46 11 6 30°
6 20 50 13 5 45°
6 20 49 14 2 60°
D A L 1 L 2 R
6 20 43 8 4
6 25 48 13 8
D A L 1 L 2
6
10 50 20
1/4”
D A 1 A 2 L 1 L 2 L 3 R
6 15 8 37 7 3.5 3
6 21 8 40 10 3.5 6
1/4” 21 8 40 10 3.5 6