User Manual

7 ENGLISH
Overheat protection
Whenthetoolorbatteryisoverheated,thetoolstops
automatically.Inthiscase,letthetoolandbatterycool
before turning the tool on again.
NOTE: When the tool is overheated, the lamp blinks.
Overdischarge protection
Whenthebatterycapacityisnotenough,thetoolstops
automatically.Inthiscase,removethebatteryfromthe
toolandchargethebattery.
Switch action
WARNING: Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
CAUTION: When not operating the tool,
depress the trigger-lock button from side to
lock the switch trigger in the OFF position.
Topreventtheswitchtriggerfromaccidentallypulled,
the trigger-lock button is provided. To start the tool,
depressthetrigger-lockbuttonfromA( )sideandpull
theswitchtrigger.Toolspeedisincreasedbyincreas-
ing pressure on the switch trigger. Release the switch
trigger to stop. After use, depress the trigger-lock button
fromB( )side.
1
2
AB
►1. Trigger-lock button 2. Switch trigger
Using the trigger-lock button for
continuous operation
Forcontinuousoperation,depressthetrigger-lockbuttonfromB( )
side while pulling the switch trigger, and then release the switch trig-
ger.Tostopthetool,depressthetrigger-lockbuttonfromA( )side.
1
2
AB
►1. Trigger-lock button 2. Switch trigger
Speed adjusting dial
1
►1.Speedadjustingdial
Theblowsperminutecanbechangedbyturningthespeedadjusting
dial to a given number setting from 1 to 5. Higher speed is obtained
when the dial is turned in the direction of number 5. And lower speed
is obtained when it is turned in the direction of number 1.
Refer to the table for the relationship between the num-
ber settings on the dial and the blows per minute.
Number Blows per minute
1 1,000 min
-1
2 1,300 min
-1
3 1,900min
-1
4 2,700 min
-1
5 3,200 min
-1
CAUTION: Do not turn the adjusting dial when
the tool is running. Failure to do so may result in
the loss of control of the tool and cause an injury.
NOTICE: The speed adjusting dial can be turned
only as far as 5 and back to 1. Do not force it past
5 or 1, or the speed adjusting function may no
longer work.