User Manual
20 ENGLISH
2. Connect the high pressure washer and the faucet
using a water hose. After that, open the faucet.
Fig.28
3. Open the cover and install the battery cartridges
into the high pressure washer and then lock the cover.
Fig.29: 1. Battery cartridge 2. Cover
4. Turn the power switch to your desired mode.
Fig.30: 1. Low pressure mode (1) 2. High pressure
mode (2) 3. OFF position (0)
5.
To eject a water jet, unlock the stopper and squeeze the
trigger. The jet continues as long as the trigger is squeezed.
Fig.31: 1. Stopper
CAUTION: The
trigger gun recoils when you pull the trigger.
CAUTION: Always hold the trigger gun by the
grip and barrel when ejecting water jet.
NOTICE: Be careful not to pull the trigger gun
forcibly during operation. It may cause the high
pressure washer to fall over.
NOTICE:
When suspending the operation for a long
the trigger to discharge the remaining water fully.
If the high pressure washer is left for a long time while main-
taining high pressure, it may not restart. In this situation, switch
inlet and squeeze the trigger with keeping the water supply for a
while. And then, switch on the high pressure washer.
When you suspend the operation, you can temporarily
Fig.32
After use
CAUTION: After operating the high pressure
washer, always perform the procedure described
in this manual. Residual pressure in the trigger gun
or high pressure washer can cause personal injury or
damage to the pump inside.
1.
2. Close the faucet and disconnect the water hose
from the high pressure washer.
Fig.33
3. Switch on the high pressure washer again.
4. Squeeze the trigger until the remaining water in
the high pressure washer is discharged.
Fig.34
NOTICE: Do not run the motor for longer than 1
minute.
5.
the battery cartridges.
Fig.35: 1. Power switch 2. Battery cartridge
6. Disconnect the high-pressure hose from the trig-
ger gun and the high pressure washer.
Fig.36: 1. Trigger gun 2. High-pressure hose
3. High-pressure washer
NOTICE: To prevent the high-pressure hose from
being damaged, remove the remaining water in
the hose before storing.
MAINTENANCE & STORAGE
CAUTION: Always be sure that the tool is
before attempting to perform inspection or
maintenance.
NOTICE: Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Cleaning the nozzle
Use the cleaner pin to remove dirt from or unclog the
nozzle.
Fig.37: 1. Cleaner pin
NOTE: To maintain the optimal performance, clean
the nozzle periodically.
NOTICE: Do not remove dirt or debris forcibly.
This may result in personal injury or damage to the
ejection hole causing deviated jet angles or poor
performance.
Detach the water hose connector and remove dirt and
Fig.38: 1. Water hose connector 2. Filter 3. Sealing
ring
When using the suction hose set (optional accessory), take
Fig.39: 1. Filter 2. Filter case
NOTE: To maintain the optimal performance, clean
Storage
CAUTION: Always store in an indoor location
where the temperature does not go below freez-
ing. If the high pressure washer freezes and malfunc-
tions, contact your local service center for repairs.
Store the accessories in the side pocket of the high
pressure washer.
Storage example
Fig.40: 1. High-pressure hose 2. Nozzle 3. Trigger
gun
If your model is supplied with the container, store the
high pressure washer and accessories in it.