User Manual

10 ENGLISH
ASSEMBLY
CAUTION: Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION: Do not touch the saw chain with
bare hands. Always wear gloves when handling
the saw chain.
Removing or installing saw chain
CAUTION: The saw chain and the guide bar
are still hot just after the operation. Let them cool
down enough before carrying out any work on
the tool.
Toremovethesawchain,performthefollowingsteps:
1. Pull the lever up while pressing its edge.
1
►1. Lever
2. Turntheadjustingdialto"-"directiontorelease
the saw chain tension.
1
►1.Adjustingdial
3. Turn the lever counterclockwise until the sprocket
cover comes off.
1 2
►1. Lever 2. Sprocket cover
4. Remove the sprocket cover then remove the saw
chain and guide bar from the chain saw body.
Toinstallthesawchain,performthefollowingsteps:
1. Make sure the direction of the chain. The arrow
mark on the chain shows the direction of the chain.
2. Fit in one end of the saw chain on the top of the
guide bar and the other end around the sprocket.
1
►1. Sprocket
3. Rest the guide bar in place on the chain saw.
4. Turntheadjustingdialto"-"directiontoslidethe
adjustingpininthedirectionofarrow.
1
►1.Adjustingpin
5. Place the sprocket cover on the chain saw so that
theadjustingpinispositionedinasmallholeonthe
guide bar.