Operators Manual

6
1
2
3
009834
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
• If the bit is not inserted deep enough into the
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this case,
try re-inserting the bit according to the instructions
above.
OPERATION
009761
NOTE:
• The size of wood screw which can be fastened
with this tool may differ depending upon the type of
material to be fastened. Always perform a test
operation to determine the size of wood screw.
Holding the tool
Hold the tool only by the handle when performing an
operation. Do not touch the metal part.
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between
fastening torque and fastening time is shown in the
figures.
M12
M10
M8
80
60
40
20
0
(204)
(408)
(816)
(612)
1.0
2.0
3.0
Standard bolt
N m
(kgf.cm)
M12
M10
M8
(S)
Fastening time
Fastening torque
Proper fastening torque
.
100
120
(1224)
(1020) M14
M14
009619
M10
M8
80
60
40
20
0
(204)
(408)
(816)
(612)
1.0
2.0
3.0
High tensile bolt
N m
(kgf.cm)
M10
M8
(S)
Fastening time
Fastening torque
Proper fastening torque
.
100
(1020)
009620
Hold the tool firmly and place the point of the driver bit in
the screw head. Apply forward pressure to the tool to the
extent that the bit will not slip off the screw and turn the
tool on to start operation.
NOTE:
• Use the proper bit for the head of the screw/bolt
that you wish to use.
• When fastening screw M8 or smaller, carefully
adjust pressure on the switch trigger so that the
1. Bit
2. Bit-piece
3. Sleeve