ENGLISH (Original instructions) INSTRUCTION MANUAL Multi Tool TM3000C 012849 DOUBLE INSULATION IMPORTANT: Read Before Using.
ENGLISH (Original instructions) SPECIFICATIONS Model TM3000C Oscillation per minute 6,000 - 20,000 (min-1) Oscillation angle, left/right 1.6 ﾟ (3.2 ﾟ total) Overall length 275 mm Net weight without dust extraction attachment 1.4 kg with dust extraction attachment 1.5 kg Safety class /II • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Specifications may differ from country to country.
accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. 21. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users. 22. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tool’s operation.
. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. Position the cord clear of the spinning accessory. If you lose control, the cord may be cut or snagged and your hand or arm may be pulled into the spinning accessory. Always use safety glasses or goggles. Ordinary eye or sun glasses are NOT safety glasses. Avoid cutting nails. Inspect workpiece for any nails and remove them before operation. Hold the tool firmly.
ASSEMBLY FUNCTIONAL DESCRIPTION • WARNING: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Failure to switch off and unplug the tool may result in serious personal injury from accidental start-up. • Installing or removing application tool (optional accessory) Switch action • 1 CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. 1.
1 2 3 4 1. Application tool installation bolt 2. Holes in the application tool 3. Adapter 4. Protrusions of the tool flange 012850 012853 When using application tools with a different type of installation section, use a correct adapter (optional accessory). Apply a sanding paper on the workpiece. NOTE: • Using a test material sample to try is recommendable to determine a correct orbital stroke rate suitable for your work.
MAINTENANCE 2 CAUTION: Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. • Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result. To maintain product SAFETY and RELIABILITY, repairs, carbon brush inspection and replacement, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts.
Makita Corporation 885123A3 8 www.makita.
