User Manual
14 ENGLISH
FUNCTIONAL
DESCRIPTION
CAUTION: Always be sure that the tool is
before adjusting or checking function on the tool.
Using the tool as cordless hedge
trimmer
installing the shear blades for hedge trimmer.
Installing or removing battery
cartridge
CAUTION:
installing or removing of the battery cartridge.
CAUTION: Hold the tool and the battery car-
cartridge.
Fig.1: 1. Red indicator 2. Button 3.
while sliding the button on the front of the cartridge.
CAUTION: Always install the battery cartridge
fully until the red indicator cannot be seen. If not,
CAUTION: Do not install the battery cartridge
forcibly.
Tool / battery protection system
-
-
placed under one of the following conditions:
Overload protection
-
application that caused the tool to become overloaded.
Then turn the tool on to restart.
Overheat protection
-
turning the tool on again.
Overdischarge protection
Switch action
WARNING: Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
WARNING: For your safety, this tool is
the tool from unintended starting. Never use the
tool if it starts when you pull the switch trigger
Makita Service Center for repairs.
WARNING: Never disable the lock function or
NOTICE: Do not pull the switch trigger forcibly
The switch
Fig.2: 1. Switch trigger 2.
switch trigger. Release the switch trigger to stop. The
left side.
Indicator lamp
The indicator lamp blinks or lights up when the remain-
also lights up when the tool becomes overloaded.
Fig.3: 1. Indicator lamp
Lamp status and action to be taken
Indicator lamp Status Action to be taken
The lamp blinks
red.
The remaining
is low.
The lamp lights up
red. *
The tool has
stopped because
the remaining
The tool has
stopped due to
overload.
* The time at which the indicator lamp lights up varies depending
-
tridge conditions.