Use and Care Manual

11 ENGLISH
2. -
ing nuts.
1
2
3
1.2. Retaining nut
3. Sprocket cover
3. Remove the sprocket cover then remove the saw
chain and guide bar from the chain saw body.
      
1. 
mark on the chain shows the direction of the chain.
2. Fit in one end of the saw chain on the top of the
guide bar and the other end around the sprocket.
1
1. Sprocket
3. Rest the guide bar in place on the chain saw.
4. Place the sprocket cover on the chain saw so that

guide bar.
12
34
1. Sprocket cover 2. Guide bar 3. Hole 4.
pin
5. 

1
1. Retaining nut
Adjusting saw chain tension
CAUTION: Carry out the procedure of install-
ing or removing saw chain in a clean place free
from sawdust and the like.
CAUTION: Do not tighten the saw chain too
much. Excessively high tension of saw chain may
cause breakage of saw chain, wear of the guide bar

CAUTION: A chain which is too loose can
jump off the bar and it may cause an injury
accident.

of use. From time to time check the saw chain tension
before use.
1. Release the chain brake by pulling the front hand
guard.
2. Loosen the retaining nuts a bit to loosen the
sprocket cover lightly.
1
1. Retaining nut