Use and Care Manual
12 ENGLISH
3.
to tighten, turn it counterclockwise to loosen.
For chain blade 90PX and 91PX:
1
2
3
1. Guide bar 2. Saw chain 3.
For chain blade 25AP:
-
ter of the lower side of the guide bar and the saw chain
becomes approximately 1 mm to 2 mm.
4. Keep holding the guide bar lightly and tighten the
retaining nuts to secure the sprocket cover.
1
1. Retaining nut
For chain blade 90PX and 91PX:
Make sure that the saw chain does not loose at the
lower side.
side of the bar.
For chain blade 25AP:
Make sure that the gap between the center of the lower
side of the guide bar and the saw chain is approximately
1 mm to 2 mm.
OPERATION
Lubrication
Saw chain is automatically lubricated when the tool is in
operation. Check the amount of remaining oil in the oil
tank periodically.
cap is tightened securely.
1
2
1. Oil tank cap 2. Oil tank (translucent)
tree. Start it and wait until lubrication on saw chain is
adequate.
NOTICE:
-
pletely emptied, add oil up to the bottom edge of
impaired.
NOTICE: Use the saw chain oil exclusively for
Makita chain saws or equivalent oil available in
the market.
NOTICE: Never use oil including dust and parti-
cles or volatile oil.
NOTICE: When pruning trees, use botanical oil.
Mineral oil may harm trees.
NOTICE: Before the cutting operation, make sure
that the provided oil tank cap is screwed in place.