Use and Care Manual

9 ENGLISH
To prevent the sw itch tr igge r fro m b eing ac cide ntally pu lled , a lock-
off lever is provided. To start the tool, depress the lock-off lever
and pull the switch trigger. Release the switch trigger to stop.
21
1. Switch trigger 2. Lock-off lever
Checking the chain brake
CAUTION: Hold the chain saw with both hands
when switching it on. Hold the rear handle with your
right hand, the front handle with your left. The bar
and the chain must not be in contact with any object.
CAUTION: Should the saw chain not stop immediately
when this test is performed, the saw may not be used under
any circumstances. Consult our authorized service center.
1. Press the lock-off lever, then pull the switch trig-
ger. The saw chain starts immediately.
2. Push the front hand guard forwards with the back
of your hand. Make sure that the chain saw comes to an
immediate standstill.
2 3
1
23
1
1. Front hand guard 2. Unlocked position 3. Locked
position
Checking the run-down brake
CAUTION: If the saw chain does not stop
within one second in this test, stop using the
chain saw and consult our authorized service
center.
Run the chain saw then release the switch trigger com-
pletely. The saw chain must come to a standstill within
one second.
Adjusting the chain lubrication


universal wrench.
1
1.
ASSEMBLY
CAUTION: Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION: Do not touch the saw chain with
bare hands. Always wear gloves when handling
the saw chain.
Removing or installing saw chain
CAUTION: The saw chain and the guide bar
are still hot just after the operation. Let them cool
down enough before carrying out any work on
the tool.
To remove th e s aw ch ain, perform the following ste ps:
1. Pull the lever up while pressing its edge.