Manualshelf

SDS

ManualsBrandsMakita ManualsDrills18-Volt LXT Lithium-Ion Brushless Cordless Impact Driver Kit (3.0Ah) with Impact XPS 35 Piece Impact Bit Set
12345
2
CONTINUED: SECTION 3. COMPOSITION, INFORMATION OR INGREDIENTS:
Common chemical name / General name
CAS number
Concentration /Concentration range
Copper
7440-50-8
23%
Iron
7439-89-6
19%
UN number: UN3480
Watt-hour rating: 6.0 Wh / 5.6 Wh (Nominal / Rated)
SECTION 4. FIRST AID MEASURE:
The product contains organic electrolyte. In case of electrolyte leakage from the battery, actions described below are required.
Eye contact:
Flush the eyes with plenty of clean water for at least 15 minutes immediately, without rubbing, and call a doctor. If
appropriate procedures are not taken, this may cause an eye irritation.
Skin contact:
Wash the contact areas off immediately with plenty of water and soap. If appropriate procedures are not taken, this may
cause sores on the skin.
Inhalation:
Remove to fresh air immediately, and call a doctor.
SECTION 5. FIRE FIGHTING MEASURES:
• Use specified extinguishers (gas, foam, powder) and extinguishing system under the Fire Defense Law.
•
Since corrosive gas may be produced at the time of fire extinguishing, use an air inhalator when danger is predicted.
• Use a large amount of water as a supportive measure in order to get cooling effect if needed.
(Indoor/outdoor fire hydrant)
• Carry away flammable materials immediately in case of fire.
• Move batteries to a safer place immediately in case of fire.
SECTION 6. ACCIDENTAL RELEASE MEASURES:
• Wipe off with dry cloth
•
Keep away from fire
• Wear safety goggles, safety gloves as needed
SECTION 7. HANDLING AND STORAGE:
Storage:
Store within the recommended limit of -20°C to 45°C (-4°F to 113°F), well-ventilated area.
Do not expose to high temperature (60°C/140°F). Since short circuit can cause burn hazard or safety vent to open, do
not store with metal jewelry, metal covered tables, or metal belt.
Handling:
Do not disassemble, remodel, or solder. Do not short + and - terminals with a metal.
Do not open the battery.
Charging:
Charge within the limits of 0°C to 45°C (32°F to 113°F) temperature. Charge with specified charger designed for this
battery.