Use and Care Manual

9 ENGLISH

To prevent the switch trigger from being accidentally

pulled, a lock-o󰀨 button is provided. To start the tool,

depress the lock-o󰀨 button and pull the switch trigger.

Release the switch trigger to stop.

► 1. Switch trigger 2. Lock-o󰀨 button

NOTICE: Do not pull the switch trigger hard

without pressing in the lock-o󰀨 button. This can

cause switch breakage.

Lighting the lamp

CAUTION: Do not look in the light or see the

source of light directly.

To turn on the lamp, press the lamp button. To turn o󰀨,

press the lamp button again.

► 1. Lamp button 2. Lamp

NOTE: The lamp will automatically be turned o󰀨 if

there is no operation with the tool for one minute.

Electric brake

Electric brake is activated after the tool is switched o󰀨.

The brake does not work when the power supply is shut

down, such as the battery is removed accidentally, with

the switch still on.

ASSEMBLY

CAUTION: Always be sure that the tool is

switched o󰀨 and the battery cartridge is removed

before carrying out any work on the tool.

Installing or removing abrasive cut-

o󰀨 wheel / diamond wheel

CAUTION: Use only the Makita wrench to

install or remove the wheel.

CAUTION: When installing the wheel, be sure

to tighten the bolt securely.

CAUTION: Do not press the shaft lock button

when the wheel is rotating.

To remove the wheel, press the shaft lock button and

rotate the wheel until the wheel cannot revolve. While

the shaft lock is fully locked, turn the hex bolt counter-

clockwise using the box wrench. Then remove the hex

bolt, outer ange and wheel.

► 1. Shaft lock button 2. Box wrench 3. Tighten

4. Loosen