Use and Care Manual

11 ENGLISH

4. Push the coupling sleeve into the water inlet until it

locks with a click.

► 1. Coupling sleeve 2. Water inlet 3. Cock

NOTICE: Keep the cock closed until you start the

cutting operation with water feeding. For how to

feed water, refer to the section for the operation.

OPERATION

CAUTION: Be sure to lock the cover for bat-

tery compartment before operating.

CAUTION: Be sure to hold the workpiece

rmly down on a stable bench or table during

operation.

CAUTION: Do not twist or force the tool in the

cut, or the motor may be overloaded or the work-

piece may break.

Cutting

CAUTION: During operation, do not bring the

tool higher than your shoulder height.

Hold the tool rmly. Grasp the handle with your right

hand and the grip with your left hand. To prevent electric

shock by accidental cutting of an electric cable, always

hold the grip by the designated portion as shown in the

gure.

► 1. Part to hold

Move the tool over the workpiece surface, keeping it

at and advancing smoothly until the cutting is com-

pleted. Keep your cutting line straight and your speed of

advance uniform.

NOTE: When the battery cartridge temperature is

low, the tool may not work to its full capacity. At this

time, for example, use the tool for a light-duty cut for

a while until the battery cartridge warms up as high

as room temperature. Then, the tool can work to its

full capacity.

NOTE: If the cutting action of the diamond wheel

begins to diminish, dress the cutting edge of the

wheel using an old discarded coarse grit bench

grinder wheel or concrete block. Dress by pressing

lightly on the outer edge of the diamond wheel.

When feeding water during cutting

CAUTION: When using a wet-type diamond

wheel, always feed water during cutting.

Connect the tool to the water supply and turn the cock

in the direction of the arrow as illustrated. Adjust the

position of the cock to obtain a gentle ow of water.

► 1. Cock