Use and Care Manual

015611

Attach the holder joint firmly along the tool, and fix them

with screws tightly.

To remove the holder joint, follow above procedure in

reverse.

NOTE:

• There are three types of holders (optional

accessory), short holder (300ml(18.3cu.in)), long

holder (600ml(36.6cu.in)), and big holder

(800ml(48.8cu.in)). Use appropriate holder joint

accordingly.

Installing rod and piston

For short holder (300ml(18.3cu.in))

015608

For long holder (600ml(36.6cu.in))

013612

ABC

013611

For big holder (800ml(48.8cu.in))

015612

015607

Insert the rod into the slit of the tool.

Attach the piston and tighten it with a screw.

To remove the rod and piston, follow the installation

procedure in reverse.

NOTICE:

• The teeth on the rod must point down.

• There are four types of pistons. Piston A and D for

cartridges. Piston B for film type packs. Piston C

for direct filling.

• Choose appropriate piston in accordance with the

type of caulking material container. Improper

piston may cause leakage or tool breakage.

• There are three types of rods. The rod for the

short holder (300ml(18.3cu.in)), rod for long holder

(600ml(36.6cu.in)), and rod for big holder

(800ml(48.8cu.in)). Use appropriate rod in

accordance with holder type.

• Always keep the rod and piston clean. Adhering

caulk may damage the tool.