Use and Care Manual

014903

Miter Joint (Fig. C)

Fig. C

004586

014911

Frame Joint (Fig. D)

Fig. D

004587

014912

Edge-To-Edge Joint (Fig. E)

Fig. E

004588

012506

To make joints, proceed as follows:

1. Fit the two workpieces together as they will

appear in the finished joint position.

2. Mark the center of the intended biscuit grooves

on the workpiece using a pencil.

NOTE:

• The center of grooves should be at least 50

mm (2") from the outer edge of the

workpieces.

• Allow 100 mm - 150 mm (4"-6") between

grooves in multiple biscuit application.

3. For Corner Joint and T-Butt Joint only

Clamp the vertical workpiece to the

workbench.

For Miter Joint only

Clamp one workpiece to the workbench with

the mitered edge facing up.

For Frame Joint and Edge-To-Edge Joint only

Clamp one workpiece to the workbench.

4. Set the depth of groove according to the size of

biscuit to be used. Refer to the table in the

"Adjusting the depth of groove" section.

5. Adjust the angle guide height so that the blade is

centered in the board thickness.

6. Align the center mark on the base with the pencil

line on the workpiece.