Product Manual

11 ENGLISH
Indicator lamps Remaining
capacity
Lighted O󰀨 Blinking
The battery
may have
malfunctioned.
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may di󰀨er slightly
from the actual capacity.
NOTE: The rst (far left) indicator lamp will blink when
the battery protection system works.
Main power switch
WARNING: Always turn o󰀨 the main power
switch when not in use.
1
2
Fig.20
► 1. Main power lamp 2. Main power switch
To turn on the machine, press the main power switch.
The main power lamp lights up in green. To turn o󰀨 the
machine, press the main power switch again.
NOTE: If the main power lamp lights up in red or
blinks in red or green, refer to the instructions for
machine/battery protection system.
NOTE: This machine employs the auto power-o󰀨
function. To avoid unintentional start up, the main
power switch will automatically shut down when the
switch lever and drive lever (if equipped) are not
pulled for a certain period after the main power switch
is turned on.
Switch action
WARNING: Before installing the battery cartridge,
always check to see that the switch lever actuates prop-
erly and returns to the original position when released.
Operating the machine with a switch that does not actuate
properly can lead to loss of control and serious personal injury.
NOTE: The mower does not start without pressing the
switch button even the switch lever is pulled.
NOTE: Mower may not start due to the overload
when you try to mow long or dense grass at a time.
Increase the mowing height in this case.
This mower is equipped with the lock key and handle switch.
If you notice anything unusual with either of the lock key
or switch, stop the operation immediately and have them
checked by your nearest Makita Authorized Service Center.
For XML11
1. Install the battery cartridges. Insert the lock key,
and then close the battery cover.
2. Press the main power switch.
3.
Pull the switch lever toward you while holding down the switch
button. Release the switch button as soon as the motor starts running.
1
2
Fig.21
► 1. Switch button 2. Switch lever
4. While holding the switch lever, push the drive lever
forward and hold it to drive the rear wheels.
1
Fig.22
► 1. Drive lever
NOTE:
You can drive the rear wheels by pushing the drive
lever forward and hold it without pulling the switch lever.