Use and Care Manual

18 ENGLISH

Cancelling tool registration for the

vacuum cleaner

Perform the following procedure when cancelling the

tool registration for the vacuum cleaner.

1. Install the batteries to the vacuum cleaner and the

tool.

2. Setthestand-byswitchonthevacuumcleanerto

"AUTO".

►1.Stand-byswitch

3. Press the wireless activation button on the vac-

uum cleaner for 6 seconds. The wireless activation

lamp blinks in green and then become red. After that,

press the wireless activation button on the tool in the

sameway.

1 2

►1. Wireless activation button 2. Wireless activation

lamp

Ifthecancellationisperformedsuccessfully,thewire-

less activation lamps will light up in red for 2 seconds

and start blinking in blue.

NOTE:Thewirelessactivationlampsnishblinkingin

red after 20 seconds elapsed. Press the wireless acti-

vation button on the tool while the wireless activation

lamp on the cleaner is blinking. If the wireless acti-

vation lamp does not blink in red, push the wireless

activationbuttonbrieyandholditdownagain.