Use and Care Manual

16 ENGLISH

2. Setthestand-byswitchonthevacuumcleanerto

"AUTO".

►1.Stand-byswitch

3. Press the wireless activation button on the vac-

uum cleaner for 3 seconds until the wireless activation

lampblinksingreen.Andthenpressthewirelessacti-

vationbuttononthetoolinthesameway.

1 2

►1. Wireless activation button 2. Wireless activation

lamp

If the vacuum cleaner and the tool are linked success-

fully,thewirelessactivationlampswilllightupingreen

for 2 seconds and start blinking in blue.

NOTE:Thewirelessactivationlampsnishblinking

in green after 20 seconds elapsed. Press the wireless

activation button on the tool while the wireless acti-

vation lamp on the cleaner is blinking. If the wireless

activation lamp does not blink in green, push the wire-

lessactivationbuttonbrieyandholditdownagain.

NOTE: When performing two or more tool registra-

tionsforonevacuumcleaner,nishthetoolregistra-

tiononebyone.

Starting the wireless activation

function

NOTE: Finish the tool registration for the vacuum

cleaner prior to the wireless activation.

NOTE: Refer to the instruction manual of the vacuum

cleaner, too.

Afterregisteringatooltothevacuumcleaner,the

vacuumcleanerwillautomaticallyrunsalongwiththe

switch operation of the tool.

1. Install the wireless unit to the tool.

2. Connect the hose of the vacuum cleaner with the

tool.

3. Setthestand-byswitchonthevacuumcleanerto

"AUTO".

►1.Stand-byswitch