Use and Care Manual

19 ENGLISH
21
3
► 1. Unlocked position 2. Locked position 3. Stopper
pin
Removing the blade
Loosen the hex bolt holding the center cover using the
hex wrench. Raise the blade guard and center cover.
3
1
2
► 1. Center cover 2. Hex wrench 3. Blade guard
Press the shaft lock to lock the spindle and use the hex
wrench to loosen the hex socket bolt. Then remove the
hex socket bolt, outer ange and blade.
1
2
5
3
4
► 1. Shaft lock 2. Hex wrench 3. Hex socket bolt (left-
handed) 4. Loosen 5. Tighten
Installing the blade
Mount the blade carefully onto the spindle, making
sure that the direction of the arrow on the surface of the
blade matches the direction of the arrow on the blade
case.
1
2
► 1. Arrow on the blade case 2. Arrow on the blade
Install the outer ange and hex socket bolt. Tighten the
hex socket bolt counterclockwise using the hex wrench
while pressing the shaft lock.