Use and Care Manual

29 ENGLISH
Crown molding stopper
Optional accessory
Crown molding stoppers allow easier cuts of crown
molding without tilting the saw blade. Install them on the
turn base as shown in the gures.
At right 45° miter angle
1
2
3
4
► 1. Crown molding stopper L 2. Crown molding stop-
per R 3. Turn base 4. Guide fence
At left 45° miter angle
1
2
34
► 1. Crown molding stopper L 2. Crown molding stop-
per R 3. Turn base 4. Guide fence
Position crown molding with its WALL CONTACT EDGE
against the guide fence and its CEILING CONTACT
EDGE against the crown molding stoppers as shown in
the gure. Adjust the crown molding stoppers according
to the size of the crown molding. Tighten the screws to
secure the crown molding stoppers. Refer to the table
(C) for the miter angle.
1
2
► 1. Guide fence 2. Crown molding stopper
(a) (b) (c) (d)
12
1. Inside corner 2. Outside corner
Table (C)
– Molding
position in
the gure
Miter angle Finished
piece
For inside
corner
(a) Right 45° Save the right
side of blade
(b) Left 45° Save the left
side of blade
For outside
corner
(c) Save the right
side of blade
(d) Right 45° Save the left
side of blade