Use and Care Manual

12 ENGLISH
1 1
3
45
3
2 2
►1. Saw blade 2. Blade teeth 3. Kerf board 4. Left
bevel cut 5. Straight cut
5. Tightenthescrews(donottightenrmly).
6. Afteradjustingthekerfboards,releasethestop-
perpinandraisethehandle.Thentightenallthescrews
securely.
NOTICE: After setting the bevel angle ensure
that the kerf boards are adjusted properly. Correct
adjustmentofthekerfboardshelpstoprovideproper
support of the workpiece and minimizing workpiece
tear out.
Maintaining maximum cutting
capacity
Thistoolisfactoryadjustedtoprovidethemaximum
cutting capacity for a 165 mm (6-1/2") saw blade.
When installing a new blade, always check the lower
limitpositionoftheblade,andifnecessary,adjustitas
follows:
1. Remove the battery cartridge. Lower the handle
completely.
2. Usethehexwrenchtoturnthelowerlimitadjust-
ing bolt until the saw blade comes slightly below the
cross section of the guide fence and the top surface of
the turn base.
1
►1.Adjustingbolt
1
►1. Guide fence
3. Rotate the blade by hand while holding the handle
all the way down to be sure that the blade does not
contactanypartofthelowerbase.Re-adjustslightly,if
necessary.
WARNING: After installing a new blade and
with the battery cartridge removed, always be
sure that the blade does not contact any part of
the lower base when the handle is lowered com-
pletely. If a blade makes contact with the base it may
causekickbackandresultinseriouspersonalinjury.
Sub-fence
Thistoolisequippedwiththesub-fenceandsmall
sub-fences.
Sub-fence
WARNING: Always remove sub-fence when
performing bevel cuts. Failure to do so may cause
seriousinjury.