Use and Care Manual

13 ENGLISH
1
►1. Sub-fence
When performing cuts except for bevel cuts, use the
sub-fence to support the workpiece.
Small sub-fence
CAUTION: When performing right bevel cuts,
fold the small sub-fences. Otherwise,theymay
contact the blade or a part of the tool, and may result
inseriousinjurytotheoperator.
1
2
►1. Small sub-fence 2. Scale
Thistoolisequippedwiththesmallsub-fences.When
performingverticalcutorleftbevelcut,ipthemupward
tosupporttheworkpiece.Theguidefencehasascale
of 12.7 mm (1/2") interval.
Adjusting the miter angle
1
23
4
►1. Fixing screw 2.Turnbase3. Miter scale
4. Pointer
1. Loosenthexingscrewcounterclockwise.
2. Adjusttheangleoftheturnbase.Usethepointer
and the miter scale as a guide.
3. Tightenthexingscrewclockwisermly.
CAUTION: After changing the miter angle,
always secure the turn base by tightening the
xing screw rmly.
NOTICE: When turning the turn base, be sure to
raise the handle fully.
Adjusting the bevel angle
Toadjustthebevelangle,turntheleverattherearof
the tool downward.
1
►1. Lever
Totiltthebladetotheleft,holdthehandleandtiltthe
saw head. Use the bevel scale and the pointer as a
guide.Thenturntheleverupwardrmlytosecurethe
saw head.
1
2
►1. Pointer 2. Bevel scale
Totiltthebladetotheright,holdthehandleandtiltthe
saw head to the left slightly, and push the release but-
ton. With the release button pressed, tilt the saw blade
totheright.Turntheleverupwardrmlytosecurethe
saw head.